Hello everyone. I am new to using EasyEda and I have a question. I want to create a board to control four steppers using an Esp32 and TMC2209 drivers. I already have everything designed and created, but I need the vcc and gnd tracks to be thicker since when the four motors and the logic part of the drivers and the Esp32 are fully operational, there will be a consumption of about 5 amps. I don't know exactly how thick my tracks should be to withstand those amperes, but if I route it with, for example, two millimeters, some errors are generated.

 

I have tried to route only the vcc and gnd tracks with that thickness but I have not succeeded, all the tracks are routed. It is not very well understood how to use the routing rules options.

 

So basically I have two questions:

 

How many millimeters should the tracks be for vcc and gnd for five amps?

How can I route only the vcc and gnd and stepper motors tracks with a certain thickness and the data tracks with a different thickness?

 

Some images:

 

 

 

 

Thank you.

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!