I'm baffled by a ratline problem I'm having with a PCB design I'm working on.  I have laid out a number of boards using EasyEDA without problems so this problem is puzzling to me.

 

I'm using a 4-layer board.  I have defined Inner2, in green, as GND.  My screenshot below confirms that because I clicked on the copper layer so the net name is shown.  The top pad for capacitor C6 also is supposed to be connected to GND, in my schematic.  I've got a via connecting top metal (red) to the GND plane trace that goes to the GND copper layer.  Yet it's shown as being unconnected.  I have refreshed the display and refreshed all copper layers, to no avail.

 

I also have tried a variation where I drew a top-metal line over my GND plane and dropped a via there.   The ratline remains. 

 

It's puzzling because I have an SMT resistor in a different portion of the board that's connected to GND and it has no ratline.  It is the vertical green rectangle shown in my screenshot.  BUT it gets even more interesting because that portion of the GND plane is a different rectangle (I broke up my GND planes due to concerns about parasicit capacitance).  If I re-route my problematic capacitor connection to THAT rectangle, the ratline disappears.

 

I found that if I placed a via over a region where both GND regions overlap, the ratline also disappears.  Therefore, I believe this is a bug in the layout program.  Word of warning.

 

What's going on?

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!