[EasyEDA pro] When exporting STEP, the Silk and Track on the top surface are reversed
Hello?
I am using V2.2.27.
I welcome and appreciate the V2.x upgrade.
I am grateful that the STEP Export issue, which was a concern, has been resolved.
For now, it is still usable, but I have some suggestions for modifications.
First, I would like to thank you for supporting Track and Silk Layer.
Previously, I created an image with SVG and processed it as a material, which was very inconvenient.
However, the Silk and Track surfaces of the Top Layer seem to be flipped upside down.
I am using Fusion 360.

If I upload the Top surface in its exported state to Fusion 360, it will be expressed as above.

The BOT side appears normal.

This looks like it's flipped upside down.
If you look at the Silk on the top and the bottom of the Track, it's normal.
In the end, it looks like the problem is because the top and bottom are flipped upside down.

I tried to mirror copy the Silk and Track on the top surface and swapped them up and down.

Now the top side looks normal. I thought it would be a good idea to print the Silk and Track on the top side upside down, even if it is a bit difficult.

Finally, I would like to ask if it is possible to implement.
I would like the PAD layer to be Fugue.
The part that is a bit awkward compared to the original seems to be the pad part.
If you compare the part with the arrow and the 3D viewer in EasyEDA, you will be able to tell right away.

I think it's great that it's supported up to this point.
However, if the PAD part is also processed as an additional layer and processed nicely, I think it will be an even better program.
I would like to thank those who worked hard to upgrade, and I look forward to good news.
Thank you.
#PCB#
Sign In Or Register Comment after
No comments yet. Be the first to comment!