My project uses a 0.5mm BGA component and I'm densely mounting small caps and resistors on the opposite side of the board using via-in pad. Most of the routing, which I'm doing manually, is fine, but for reasons that are unclear, some routing of traces gets balky or won't even start. Sometimes I can start a trace and then finish to connection by dragging one end of the trace to the pad, then adjusting the trace path manually. Other times I can't even get a trace to start. If I am successful in connecting the traces that don't want to connect themselves, DRC check is fine. This seems like a bug. Is this a known issue? I think I can resolve the problem by importing the project into EasyEDA Pro, but i prefer to use Standard since that is what I an used to,

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!