Hello,

Most of the PCBs I design are for Audio devices where management of the audio signal zero-volt reference and GND need to be carefully separated, however, at specific points these will need to be linked. Therefore having the ability to link the signal-ground net to the GND net without causing DRC errors is really important.

I know this can be achieved by adding a component, such as a 0Ohms resistor works but this seems a bit a pointless.

I also know this has been raised in the past as I found several other posts but couldn't find if this feature is now available in EasyEDS std?

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!