I am about to get a board built but wnen trying to export it, I am getting an error about ratlines not being connected.  I have changed the ratline colour to bright yellow and suppressed almost everything else, but still can't see the problem.  Log reports 98.88% completed.

If it is a clue, I occasionally get the attached error when importing changes.  Confirming the change doesn't stop it from reappearing later.

 

I suspect that I have now sorted it.  There was an Ethernet socket with an incorrect footprint.  It had top layer pads where the holes should have been and so the footprint had more numbers than the symbol.  The ratlines error was a red herring.

 

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!