EasyEDA layout check, XLR boxheader to Hypex amplifier board
I did my first pcb design and although I think it is sort of correct I would love for some people with expreince to have a look.
It has two XLR inputs at the top. And a box header at the bottom. The routing is correct that's not what I'm worried about. The issue is more the grounding, the thickness of the paths, the holes..
- The red paths are 25mil, is that good for audio (input audio from a pre amp before amplification)?
- The grounding in blue I put on the back side because it crosses the signal paths. It's not the signal ground but just the case ground, I routed it to the screw holes. Makes sense?
- The box header holes have 'solder mask expansion' set to 'general', seems to be 2mil, is that enough?
Any other ideas and suggestions?

Circuit Design
Sign In Or Register Comment after
No comments yet. Be the first to comment!