I just made boards on JLCPCB and found out that the G and S terminals on the datasheet and footprint are swapped.  I had to manually swap and resolder those pins to make my board work, and JLCPCB won't even admit their mistake.  Others beware....

This is from the original datasheet 

https://www.lcsc.com/datasheet/C19632011.pdf

I later found the datasheet from a similar part at https://www.aosmd.com/res/datasheets/AO3400A.pdf and hand soldered using these pins and miraculously it worked.

 

Do not trust the datasheets from LCSC and the supplied footprints from EASYEDA!

#Component#
#Component#
Technical Discussion

No comments yet. Be the first to comment!