EasyEDA(Standard) Is this PCB OK, so far?
Hello.
I am a Newbie to the EasyEDA (Std.), having failed to make headway in KiCad, I migrated to this site. I am currently working on my first project, which is a PCB that has mounted on it a SMD balun (transformer). The purpose of this balun PCB is to transform the 200+ Ohm balanced RF signal (778 MHz) of a Folded Dipole antenna down to the 50 Ohm coax cable. The PCB will be attached to the antenna, and the coax cable will carry the signals (LTE) down from my rooftop to the external antenna input of my mobile (cell) phone.
I have been struggling for days to try to get the two feed-in traces on the board, that connect to the secondary windings of the balun/transformer, to be balanced and symetrical so there will be no RF diferences in impedence. I have tried every thing I can to achieve this, and the attached screenshot shows the unsymetrical placements of the tracks, where they connect to their respective pins on the balun. I have also tried to attach a close-up screenshot of the relevant issue, but these forum posts only appear to allow one image per post.
My understanding is that EasyEDA std does not have the function where I can enter X and Y coordinates, and the end nodes of the traces will then align themselves to those coordinates.
So, does anyone have any idea how traces/tracks can be placed exactly to the designated grid coordinates? In the screen shot of the entire PCB, J1 and J2 at the top of the board will be screw holes for securing the PCB to the antenna element, as well as carrying the signals to the balun. J3 and J4 will be the connections to the coax shield braid and the central signal wire, respectively.
I would much appreciate any light that could be shed upon my ignorance!
Krisby.
#PCB#
Sign In Or Register Comment after
No comments yet. Be the first to comment!