Another newbie to EasyEDA.  I created a schematic for a board with 2 DPDT relays and a few other parts (snubber diode, LED/resistor, etc.) where the relay NO, Common and NC connections are intended to have pads for external wiring.  They are intended to carry fairly heavy current so I set the Pads at 3mm and Holes at 1.789mm.   I couldn't find anything for the schematic for a pad output, so I left them unattached. When I created the PCB, I added the Pads and Tracks.  However the DRC check shows Errors, (Picture here) 31 of them for the pads and the traces that I added.  I couldn't find out why!!!

So, I went back to the schematic and re-created the PCB and tried to add just one connection , and of course it shows a DRC Error:

  gge3254-gge3248 (-3mm, need more than DRC (0.152mm)

A picture of the Error is here. (I couldn't get the forum to show the picture)  This is the single error just to play with but I can't find a solution.  I can't figure out what to do! 

I have another VERY similar board that I created and it doesn't have any errors, shown here. 

Mike

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!