Small issue : PCB Layout prefix display not always saved
- Create a PCB layout from a schematic
- Add a copper area (GND, say)
- Set "Copper Zone" to Invisible
- For a few components, set PrefixDisplay to False.
- Save the PCB
- Close PCB
- Reload PCB
-> The PrefixDisplay is still set to False for your components - Set "Copper Zone" to visible
- Save PCB
- Close PCB
- Load PCB
-> Verify that the components whose PrefixDisplay had been set to False are now "True"
Note that it is necessary to toggle the copper zone to trigger the behavior. There may be other triggers, but this one is replicable 100% of the time.
#Bug Reports#Bug Reports
Sign In Or Register Comment after
No comments yet. Be the first to comment!