Hi there. I was wondering how I could go about either panelizing or ordering two separate PCBs. One would be the actual usable pcb, and the second one would be a flat piece of FR-4 to act as the case when standoffs are used. How can I go about ordering this? When I attempt to panelize the project it just doubles the board outline. I am assuming the fab house would just duplicate the design with through holes onto it. So how can I go about adding just a sheet of FR-4 to my panelized order? Thanks! Sorry if this is poorly explained. I would essentially just like to have the panel be the board with through holes, and the second half of the panel be case component as seen here:https://cdn.shopify.com/s/files/1/0515/5209/2347/products/image2_5112cf64-b2d7-43ab-bf45-396159460007_1000x1000.jpg?v=1626910726
What the project currently looks like:

Hi,
This is my second time using EasyEDA. First time was pretty simple. When I generate the schematic the D1 mini shows twice. What am I supposed to do with that? I expected holes that would take the board's header pins, but instead there are two board to place on the PCB. What am I doing wrong?
Here is a link (hope this is public): https://oshwlab.com/savijone/garagedooropener
Thanks,
Jeff





