In the online gerber viewer there are broken links (encircled in red):

e.g. capabilities is https://cart.jlcpcb.com/capabilities/Capabilities which is still in the cart.jlcpcb.com subdomain. while the working link would be www.jlcpcb.com

https://www.amazon.com/Wishiot-ESP8266-Burning-Development-Programer/dp/B08BXMGVNM/ref=sr_1_38?crid=3VVQ387LFO2OH&keywords=esp8266+12f+lipo&qid=1657039607&sprefix=esp8266+12f+lipo,aps,110&sr=8-38
I am using the ESP12F and I like that idea but am unsure on how to locate (or get a copy of that setup) these exact pins as compared to the headers I am using now (The ones that seem to lets the esp12f squeeze into place). Any pointers in the correct direction would be greatly appreciated. :)
Is it possible to create differential pairs with a certain impedance ?
I read the reference material:
https://docs.easyeda.com/en/PCB/Route/#Differential-Pair-Routing
But I didn't find the answer to my question there.
I'm making a board using a specific chip. According to the datasheet, differential pairs with a certain impedance are needed. How to calculate the differential impedance to create a pair of USB data lines in my project.
I bet this is possible in Altium Designer. Like here?
Hello. In my last two projects made in the online editor, I see stubs instead of a preview of an electronic circuit or a printed circuit board (and oshwlab too). What am I doing wrong ?
https://oshwlab.com/hobbyele/guitar-shaped-audio-pcb-amplifier-smd




