A way to join traces on different nets?

Hi,

I want to lay some wiring out on my board (see blow) and be able to copy chunks of it *before* connecting to the associated components.  It's for capacitive touch sensors.  The problem comes when I try to connect the wires.  Would I be correct in thinking that this post essentially means "you can't"?  Could a way be developed to override the logic that says "these are separate nets - you can't join them"?

I've encountered the same issue when doing more conventional wiring: I'll delete the bits I don't like, then try to reconstruct them better, but sometimes they won't join.  Or if I try to construct one end of a trace starting at one component, then construct the other end starting from the other component.  I'm sorry I'm a bit vague on these more conventional scenarios because it was a few weeks since I last came across it.

Thanks
image.png

#Feature Requests#
Feature Requests
UserSupport: Please prioritize the fix the Add Vias feature

Dear @UserSupport, please fix this issue.

The workaround there is confusing and a little onerous, but works if you're only adding vias to one net, e.g. GND vias. But if you need to do both power and GND, then it becomes even harder.

Just my vote, but I really think this bug should be prioritized.

#PCB#
Circuit Design
"No Solid" keep-out on ALL layers?

Hey folks, I need to add a keepout on all layers for a symbol. I can't seem to make it work for more than a two-layer board, however, since you can't set a "no solid" area to "multi-layer".

See this part. Note that at the bottom there is an antenna keep out, and it has two "no solid" rectangle regions set to "top layer," and "bottom layer" (silk screen hidden):
Screen Shot 2021-09-16 at 1.25.43 PM.png

But when i use it on a 4-layer board, the inner layers don't get kept out:

Screen Shot 2021-09-16 at 1.26.32 PM.png

Is there a way to fix this in the footprint rather than manually adding a keepout to my final PCB design?

#PCB#
Circuit Design