According to the image from https://jlcpcb.com/capabilities/Capabilities under Panelization:
https://jlcpcb.com/client/image/pcbCapabilities/panelization1.139771a9.jpg
it would seem to be OK but I have a PCB ready to submit and before I do I wanted to check if it is OK to have a slot in the PCB that crosses a V-Cut line like where the little hand is on the left in the image below?

Hello, im designing an Led matrix and when i wanted to check the prize by quoting for an PCB with assembly I got the wrong quantity of parts (instead of 110 pieces of Led's (Ws2812b) and 110 capacitors (CC0603KRX7R9BB104) which are all parts both are shown in the assembly only as 22 parts. So i asked in this forum and i got a replie that this can happen if there are not enough parts in stock and i should just wait because stock is low. I wandert because stock was at 66000 parts and because both components were scaled down to a fith so i replied but i never got an answer. This was already around two months ago and there is still the same problem
Here are the files. Pls. note that this is not the complete design.
Thanks
Hi guys, So after many weeks trying to do my first PCB project I've finally finished it, I have checked my schematics and my PCB Layout several times and many of then I found some mistakes that had to be fixed and I fixed it, but I'm not 100% sure if my board is ready for manufacturing. As I'm not an engineer, a design or an electronics student, just an 18 years old hobbyist trying to transform my dreams into reality, I'd like to receive some advice from engineers or designer about my board, I've based my project in 2 existing schematics the (Arduino Mega 2560) and the (Easy VR 3 shield) but I did a lot of modifications, so if anyone could take a look at my project I would be very grateful, you don't need to see the entire project, just spot some beginners errors or give me some advice to help me improve this board. This is the link to my project: https://easyeda.com/Natanaelprado/nex-discovery-board-rev1
#General Discuss#
!
ates are not correct. Please help me understand the reason


