EasyEDA is not good at handling the use of characters in file and other names and fields.
Here is one example.
In response to a user post:
https://easyeda.com/forum/topic/Package_is_not_assigned_Please_assign_a_package_-DzLWwuGEC
about a package error when converting a schematic to a PCB the problem was traced to a `-` character in the package name.
The package clearly existed in the System library but was not being accepted by the PCB conversion process.
To fix this I had to replace the `-` character with a`_` character in the package name.
(Note: I am not sure but I think the hyphen character used to be allowed in part names?)
Another example has been where a user has submitted a Gerber archive with a filename created from a Project in EasyEDA has a `&` character in it.
Uploading this archive to the JLCPCB Gerber Viewer failed but uploading to the EasyEDA Gerber Viewer worked OK.
The problem is that EasyEDA allows the creation of Gerber zip archives with special characters in the name and the EasyEDA Gerber Viewer accepts and opens them. The JLCPCB viewer, however, does not. I haven't checked what gerbv does.
-
The behaviour of filename assignments and acceptance in EasyEDA should be consistent with standard practice and should be the same across all parts of the tool suite, including interfaces and interactions with LCSC and JLCPCB.
-
User warnings should be generated when illegal characters are entered as filenames or in some other fields such as netnames.
JLCPCB Gerber Viewer rejects an EasyEDA generated Gerber zip from this project:
https://easyeda.com/whiskyfan/linear-optical-interface-tube-audio-3-0
The user's post about it is here:
https://easyeda.com/forum/topic/Gerber-file-incorrect-c9ea7462d5ce4eb6bca89711bf62dc9e
This looks like a bug in the JLCPCB Gerber Viewer.
It reads OK in https://gerber-viewer.easyeda.com/
#Bug Reports#Hello, i want to put multiple PCB's in one big seperated by V-Cuts, but when i copy-paste the "main" pcb every copy changes the part prefixes like from C1 to C2.. C3.
How do i prevent that? Or do i have to change all the prefixes after pasting by hand?
See right (copy)
https://i.imgur.com/scwaJ8X.png
I've never used this manufacturers switches before, so I don't know how to read their schematic symbol for this switch.
I'm assuming that the rectangles correspond to each of the contact pins, so, by that logic, the central rectangle (pin) should be the common contact. I am however not sure of this, so if anyone could assure me that I'm correct, or know what the symbol is actually corresponding to, I would highly appreciate it!
I would also like to know what power it can handle, since it doesn't say anything in the datasheet.
#General Discuss#





