BUG
Concise problem statement: Autoroute times out after changing parts to new footprint
Steps to reproduce bug:
Load project https://easyeda.com/boxxofrobots/New_Project-5828cd40bdf748ee98de0c00a8528b95
See how relatively simple it is
Observe how it refuses to route signal pins and times out when routing IC1 and IC2
Results:
Expected results: A routed board
Browser: Ubuntu/Firefox
#Bug Reports#This is my project.
https://easyeda.com/boxxofrobots/New_Project-5828cd40bdf748ee98de0c00a8528b95
I cannot seem to get this to complete no matter what. It's a pretty simple board and yet, even after relocating the parts dozens of times and even making it 4 layers, the autorouter seems to get tied up at the same place - laying out traces for a user contributed part, IC1. Can anyone tell me what I am doing wrong, or is there something wrong with the part spec? It has a schematic symbol and footprint, but the router simply refuses to get past laying out the surrounding circuitry. Often it gets hung up running the same trace over and over.
#PCB#I don't know if this should belong to bug reports category, but whenever I place an IC I have to check for available packages other than SOIC-16, the dimensions aren't right.
You can go check the pdf: https://www.centralsemi.com/PDFs/case/SOIC-16PD.PDF
Thanks.
Hi! wonder if it's possible to manufacture front panels as PCB like this http://www.knutsel.org/wp-content/uploads/2015/04/IMG_20150321_112121.jpg
This requires making large holes. Is there a maximum diameter of the holes that I can put (using pads or vias)?
#PCB#Feature Request
-
Brief title for your desired feature: Score of usability, Rating of useful
-
How would you like the feature to work? In the component database, there must be a button for rate the component, a button for adding a review or comment.
-
Why is this feature important to you? This function is important for all of us, because we can not blindly trust the components. Why? See below. In addition, the database, especially the user-defined components, execuse me, but, gradually turns into a dump of garbage.
Here's what happened:
While drawing a new board based on stm32, I took from the database a suitable component for the microcontroller. This component was in the 'System Components' section (even, not in the 'User contribution'). I drew a schematic, traced and manufactured the circuit board, installed and soldered all the components, turned on the power... Overcurrent, as if a short circuit occurred.
Having dealt with the reason, I found that this schematic component contained a critical error, reversal of the ADC power supply pins!
Here is that component: https://easyeda.com/Mstef/component/STM32f103CBT6-chtrDd8ki
With the help of a microscope and a Jedi sword, I was necessary cut the tracks and restore them in the right combination.
#Feature Requests#