Hello,
I have a few components which footprints are in mil, some components are in mm.
I set the PCB grid to 10 mil with alt grid to 8 mil.
I don't like too fine alt snap because it makes things slow and not nice.
My question is how should I lay tracks from pads that are off grid.
This is what I've tried.
1) Start from one pad, route the track to some where near the other pad, terminate the track by right-clicking. I can't continue to the end pad because it won't snap into the center point of the pad.
2) Continue from the other pad, and meet the track at the terminating point.
It works fine, but the problem happens when I want to move the segment which contains the "join".
The join point doesn't move when I want to move the segment a little to avoid vias ... etc.
Am I doing the right thing? Is there anyway to make the track snap to the center of the pad?
I browsed through some tutorial but can't find it. I found this
https://easyeda.com/forum/topic/A_few_little_things-IKSM4Ygar
Some pointers to the right tutorial would be appreciated.
I wonder if that's the only way?
Thank you guys!
Best regards,
Jeff
I just finished designing the schematics together with the final PCB. before i made my order i wanted to be 100% certain that my circuit will be functional.
here is the link https://easyeda.com/blutbad3/conifa-kz9vfY6sO
It's an Energy management system that uses the 8051 microchip with the GSM SIM800l module to send wireless connections over radio frequencies of any GPRS service provider through texts. the Sim800l requires a max of 3.5v so i'm using 2 dc-dc converters, one for the SIM800L module and the other for the 4 relays that need 12V optimum. and i also included a UN2003a relay driver and an LCD display "16x2".
There are several LST connectors as i had planned earlier to just plug in the several harware. that is the LCD,SIM800L module and the 2 DC-DC convertors.
thank you. your help will be very much appreciated!
#PCB#Feature Request
Brief title for your desired feature:
Text entry same PCB editor as in Schematic editor
How would you like the feature to work?
At present, when the user:
(i) opens a text box;
(ii) enters some text;
(iii) presses return then;
(iv) types more text and then;
(v) exits the text box,
then the user expects to see the text up to where the return key was pressed on one line and then rest of the text that was entered after pressing the return key on a new line.
-
When entering text in the Schematic editor, that is what happens.
-
However, when entering text in the PCB editor, the return key press is ignored and text continues on the original single line.
Why is this feature important to you?
It makes editing text onto a PCB easier especially in the Documentation layer!
Please also see:
https://easyeda.com/forum/topic/Enter_doses_not_work_in_text-x1c0Yy863
#Feature Requests#