Hi all:
Am trying to learn more about ceramic chip antennas. I found this webpage: Chip Antenna Layout for 802.11 Applications - Johanson TechnologyI have seen a lot of datasheets with drawings similar to these. Before I even get to the point of trying to design a circuit, impedance match, design pi filter, etc. I have some basic questions about these datasheets. For example, I see vias which makes me think there is a dedicated Ground layer, but there is also the large "orange" layer in the figures which is labeled "Ground". So is this saying if I have a dedicated ground layer that I should also have a solid "Ground" region on my top (signal) layer and connect them with vias? I am assuming that large orange area labeled "ground" is on the top layer because the microstripline and pads for the antenna are also orange. Or maybe this is just for a 2 layer board? Also, what is the grey area around the microstripline?
Any help is appreciated.
I'm new to EasyEDA, and have successfully captured my schematic, generated a 2 layer PCB, placed the components, added tracks on the top layer, and added a ground plane (copper region) to the bottom layer.
My goal now is to connect the components' pads to the ground plane, by adding vias and then adding tracks from the appropriate pads to the vias. I'm getting errors when I do this.
I reduced my circuit down to a minimal example which shows the problem, available at https://oshwlab.com/srobertjames/minimal-example-led . There are two pads which need to go to GND. I've added a via next to each one. EasyEDA does not let me connect the pads to the vias: when I try to draw the track, it will stop outside the via. How do I connect the via to the pad?
Also, in some cases, a yellow X appears on or near the via. I do not know what that signifies. Likewise, the 3D view does not seem to show the ground plane (copper region) on the bottom of the board.







