Hi, this is my project https://u.easyeda.com/account/user/projects/index/detail?project=979a4395a22b48aebfca584fd612b9c7&folder=all and i want to order a PCB, but i'm unsure, how to pick the SMT parts that will be automatically assembled in the factory and parts, that will be sent to me for manual assembly?
What i want:
I want JLCPCB to manufacture the PCBs and to factory assemble basic parts.
I want JLCPCB to also solder on the mosfets.
I would prefer them to assemble all the parts but i read there is an additional cost for each extended part, because they need to swap the components on the robot feed.
Is there a way to choose if the basic/ extended part will be factory assembled on the PCB? For example "AO3401A - Yes; XT30U-M - No"
I have been using the pro version and have discovered some issues with its autorouting engine that I have reported HERE
It is clear that the Pro version and standard versions do not share the same autorouting engine, and that the more mature standard local routing engine is far superior. I would even go as far as to say that the Pro version autorouting engine is beta level software at best.
I would therefore like to propose that the option to use the existing mature local autorouting engine be integrated into the pro version.
I assume that as the local autorouting engine is a standalone program it accepts an input from the editor and should therefore not be too difficult to integrate.
Alternately if this is not possible can some clarification on how the local autorouting engine can be used as a workaround. i.e. is there a workflow that allows the project to be exported, run in the local autorouting engine and then reimported?
/DM
#Feature Requests#I used the "one click" method in EasyEDA Pro to order a PCB + Assembly from from JLCPCB. Here is my project: https://oshwlab.com/carlk3/rp2040-sd-card-dev. I got a question from Susie at JLCPCB:
As shown below, it seems that the inner layers are positive film pattern.
Is that Ok to proceed per file directly?
...
I'm not really sure what's going on here. In Layer Manager, I have:

I read about the "Negative film effect" in the EasyEDA Pro Tutorial, but it's not clear to me how to switch it from positive to negative. My intent is to have (mostly) solid Power and Ground inner planes.
In general, is there any real difference between a "Plane" type inner layer and a "Signal" type with a copper pour? One is negative film pattern and the other is positive? Is the end result the same?
I'm not trying to do anything tricky or unusual here. I just want a normal 4-layer board with power and ground on the inner layers. It sounds catastrophic to accidently swap positive and negative film patterns! How should I proceed?
#PCB#














