Questions from a first timer

I am attempting my first PCB and not sure if what I produced is missing anything obvious.

The concept is a female header connected to a PCB that will route those connections to plated holes where I can use an alligator clips.

Here is an example of what I am hoping the circular plated connectors would resemble: https://www.adafruit.com/product/3333

And here is what I have created: https://easyeda.com/amazingjoe/copperbreakout

Questions:

  • Do I have everything in place (solder pads?) that I would need to solder the female header?
  • Is this right putting the traces on the top layer and soldering on the bottom layer (to attach the female header)? What is generally best practice for placement of traces?
  • In the example the holes have copper plating around them and also to the edge. Is that a copper pour or is it called something else? I can probably figure it our with some Googling if I know what it is called.
  • If there are any super obvious flaws (other than the trace lines / through holes being a bit uneven) please share.
  • Should this be a single layer PCB or does it need to be 2 layer to have the soldering pads on the bottom layer. (Do I have anything on the bottom layer (pads)? It looks like I do when I view the Gerber visualization)

Thank you for the time you spent reading this post and any feedback provided.

#PCB#
Circuit Design
Error in Update PCB with subparts across more than one schematic sheet.

If I have subparts spread acroos more than one schematic sheet then if I save, close and reopen a whole project then when I do Update PCB/Import Changes, the PCB Footprint for the subpart device is deleted and then added again.

If I have all the sub parts on the same schematic sheet then this problem does not occur.

This is a bit tricky to reproduce...

There is a project to demonstrate the problem here:

https://easyeda.com/andyfierman/error-updating-pcb-from-multisheet-schematic

Description of problem:

I have a symbol made from subparts and i put some subparts on one schematic sheet:

image.png

and some on a separate schematic sheet:

image.png

and then convert to PCB:

image.png

,but after I save the new PCB and then close the whole project and then reopen the schematics and the PCB and then do Update PCB, I get this message:

image.png

and U1 is moved further down towards the lower right corner.

image.png

#Bug Reports#
Bug Reports