Hello !
I made a schematic and a pcb ( https://easyeda.com/Spl4sh_/led-blink-frequency ) using this fritzing project that i modify from this : https://www.instructables.com/id/Blinking-LEDs-to-the-Frequency-of-Musi/
I want to know if my schematic is correct and all my connections between components on the pcb are correct.
If I made mistakes or any noob error, just correct me ! :)
I want to use the atmega in standalone, all the systeme is powered by a 5v power supply
Thanks !
#General Discuss#I have some cases where I'd like to use Holtites, which are intended to press fit into plated PCB holes. The problem is that the Holtite manufacturer specifies a tolerance of +/- 0.05mm for the holes (finished size after plating), but the JLCPCB specs are +/- 0.08mm. Is there any way to accommodate this? Typically this would only apply to one hole size (e.g., 1.47mm finished) on a given PCB, if that helps.
I believe some people solder Holtites, but that's a bad idea for a couple of reasons, so I'd rather not.
https://www.te.com/usa-en/product-6-1437514-8.html
Fred Wright
#PCB#









