I have a switch that is a dP3T slide, and the two poles come from a BNC. When i examine the PCB, i see connections that don't match the schematic they came from. How can that be? I am so close of having these made, but I am very careful to examine everything, but now I can't trust what the autorouter is doing.
Here is the board https://easyeda.com/joe.massimino/20db-attenuator
So I looked at the schematic and it is correct, so I ran it to a new PCB and what I think is going on, is the pins on the switch are misplaced. So I'm trying to figure out the next step.
So after looking at other parts that resembled the same switch, none had the same perfect measurements as what I have now. So my only recourse is to wired the board myself, is disregard using autoroute.
Update: I can't create a PCB with just parts, it will not allow it. So what I need is to get a properly wired DP3T switch , and none come up in the library when I search. Maybe someone has one that they can give me, or I will have to edit the switch I have.
#PCB#Hi, I keep getting stuck oat 64% completion on my project.
https://easyeda.com/editor#id=|caf483192bf84b51be0d8045e7a95afd|f21e438b7194455bbc43fd88fc774986
I originally had it is a 2 layer board, but added another layer, then another, and it's still not completing.
Im using the v0.7 local router.
Hoping the good people here can give me some more advice on what to change to get it to complete.
The next 3 posts are my local router CMD dump
#PCB#This is my first PCB design. I have limited electronics experience so here goes.
The PCB is almost exactly how I want it to me except power is not connected in all the correct places i.e. with reference to the attached PNG I want to move the lines currently going into the connector circled in green to where the green arrow points but I cannot get this right.

My project can be found here
All good, I got it sorted. I had left out some detail.
#PCB#


