I'm setting up a circuit to simulate a RLC filter. As explained here(https://docs.easyeda.com/en/Simulation/Chapter4-Introduction-to-using-a-simulator/index.html#The-ground-node-MUST-NOT-have-a-Voltage-Probe-attached-to-it), my circuit should have a power and/or a signal source.
When I'm in the circuit editor, where do I find the power source so I can add them to my circuit?
- I can't find them in the "Commonly library".
- In the "Library", selecting "Search Engine = EasyEDA", "Type = Spice Symbol" and "Classes = System", I can locate a promising section named "Power Sources / Spice Sources". In it there is a VOLTAGE_SOURCE. When I place it in my circuit, the LTSpice netlist export stops complaining and works. However, when selecting this component, it shows no section "Voltage Source Settings" where I can configure the source.
My question is: where do I find the nice power sources that are exemplified here: https://easyeda.com/editor#mode=sim,id=33ceeaef756d4e4d81aef87c9b9f25ea
Best regards,
Jean-Michel Gonet
Hi guys,
Thanks in advance for your patience, I discovered EasyEDA a few days ago .. (but spent quite some time on it since then and love it ! :) )
I need to create a board (actually, 5) that will interconnect an Arduino MEGA and 15x ZHT-103 sensors.
The MEGA is already equipped with an ethernet shield.
It’s a simple design, I got it working straight forward with 1 sensor and just 'adapted' by adding more sensors .. but before ordering and soldering the all thing, I would like some kind of confirmation =)
I'm not certain that powering the thing the way it is (the MEGA powers the all thing, he's getting 9V as input through DCA.) is the key, nor if capa and resistances are still correct or should be adapted ..
Thanks a lot in advance to those who'll throw an eye on it :)
Any comment welcome.
https://easyeda.com/editor#id=|4d16cd6c5c9c481384d19dc363bf095d|438fdd5409314760a6e2a77b61c9756a
ZHT-103 datasheet : https://datasheet.lcsc.com/lcsc/2201121700_ZHT-ZHT103_C2935356.pdf
Hello,
I am making a Charge Discharge Project for 18650 batteries. I am using TP4056 and ZB2L3 modules. The idea is to make a PCB that can be stacked one next to each other and be able to make them work using the same power source. I have been searching for a good solution for many days but cant find something appropriate. I want to create a connection to PCBs so they can use the same power supply.
Here is a link to the project: https://oshwlab.com/leopardi/battery-capacity-charge-discharge_copy
Thanks a lot.






Hello.

