I'm new at this, so please forgive me if I have overlooked rookie mistakes that could be found on the forum...
This "Sine/Square Wave Oscillator" circuit (I don't need the square waves) was taken from "IC Timer Cookbook" pp 203-204, by Walter Jung Pub 1977. And yes, I'm that old, bought it when it came out ;-)
It's now online as a .pdf here: http://vtda.org/books/Electronics/ICTimerCookbook1stEd1977_WalterGJung.pdf
I modelled the "Minimum Component Astable" on page 116 first, and the simulation worked fine after switching to the pulse supply someone recommended to kick-start the timer (that did the trick).
The op amp was selected using shift-F, as was the 555 timer and all the resistors and capacitors.
I did get some help regarding the 'too complex' issue, but I still am not getting what I should get for the output... see my comments below.
I could use some more guidance, here.
Much appreciated.
Here is the link to my project: https://easyeda.com/MaskNerd/sine-wave-oscillator-2 is the link for examining the topic. ... in the share box I found this link also, and I don't know what it is: https://easyeda.com/editor#id=5f0bd2761fc64a618ef14ea5eb3ccc46
Here I want to show you my newest video on youtube at Johnny's Desk. I tell you, what to look for when designing PCBs and how to order them with EasyEDA & JLC PCB. Please have look at it and tell me, what you think of!
How to design a PCB with easyEDA & JLC PCB + Song - Johnny's Desk

Hi,
Never done a ground plane before so I would like to get feedback as to whether my approach is correct.
Please refer to this very simple schematic and PCB layout: https://oshwlab.com/jalsop/ground-plane-test
I did the following:
1. Positioned the through hole components
2. Routed the non-GND tracks manually, including a via and a track on the bottom layer.
3. Added a copper area assigned to GND and placed it on the bottom layer
This seems to have successfully made all the GND connections.
Could someone take a quick look at the PCB 3D view and advise if everything is ok.
I am not totally clear on how the +5V pin on the power jack avoids being shorted
to the ground plane. I'm guessing there is a small ring of copper around the pin, and
then a blank area separating it from the ground plane? Its hard to tell so I would
appreciate learning from others who have already done this.
Thanks in advance for any feedback!







