VCC, +5V netlabels not working in simulation

I was trying to design a simple amplifier circuit in simulation mode in EasyEDA, and after connecting to GND and VCC netlabels, I was very confused as to why it was telling me I had no voltage sources, once I tried to run the simulation in DC OP mode; specifically, this message:
"Current circuit doesn't has Voltage Resource or Current Resource symbol, please place it first at left side EELib or Spice Library"
After digging a bit, it seems like VCC/GND netlabels are not being associated with a voltage source anymore. I tried opening this circuit
https://easyeda.com/andyfierman/vcc-vs-5v-netflag-problem , which mentions a slightly different problem triggered by two voltage sources in the same net, and:

- for Sheet1 (an example presented as working) File -> Export Netlist -> LTSpice fails with the same error
- for Sheet4 (also presented as working)\, it ignores all Netlabel voltage sources in the export

Is this intentional, or a regression?

For anyone with the same issue, I managed to circumvent it by replacing all voltage netlabels by its explicit equivalent: a DC source connected to GND.

#Bug Reports#
Bug Reports
Associated model not detected

Model: https://oshwlab.com/jonasforssell/mosfettest



I get a warning message saying XM2 is not associated with any model.

I am not sure why the associated subcircuit is not detected in this model.
I have used Andys generic N-FET model as a starting point (why is this not in the default library?)

The strange thing is that I remember it used to work so I must have made some small error.

Many thanks for any assistance.
/Jonas

#Simulation#
Circuit Design