This allow to get solder paste stencil hole smaller than the pad.
(See Footprint page 9 in http://www.st.com/content/ccc/resource/technical/document/datasheet/a7/86/d3/98/2c/7f/4b/d2/CD00217829.pdf/files/CD00217829.pdf/jcr:content/translations/en.CD00217829.pdf)
Hi,
I would like to simulate the frequency response of an experimental circuit that I use but I need some help.
The circuit is composed of a tunnel junction of impedance Z=16000 Ohms that is linked to a RF electrical source (50 Ohms) through coaxial 50 Ohms wire (around 5m ).
The story is that this tunnel junction is emitting light, and when I sweep the AC voltage applied to the junction from 20MHz to 350MHz, I observe regular peak in the light intensity, spaced by 45 MHz. I think that this phenomenon is caused by mismatch impedance. The electrical power feeding the junction to emit is function of the frequency. I assume that the impedance of the junction isn't constant because of its IV caracteristic, but a constant impedance could be a good begining.
I would like to confirm my interpretation with a simulation but I don't know how to simulate this. I tried but it difficult for me to observe the result with WaveForm.
the project link that I did: https://easyeda.com/mickael.buret2121/tunnel-junction_simu
Result from APD measurements (peaks maybe due to the non linear response of the tunnel junction because of the IV caracteristic)
















im900