First time user of EasyEDA here and I am trying to use the DRV8825 stepper motor driver carrier in my design but always get lots of DRC errors saying "track2pad" and "track2track".
All the errors have to do with the U1 (DRV8825) component. Any idea what could be wrong? I put together the simplest example circuit I could think of to illustrate the problem (see picture below). I have played around with the DRC settings but to no avail.
/Daniel
#PCB#Feature Request
Brief title for your desired feature:
Add dielectric type to EasyEDA ceramic caps in library
How would you like the feature to work?
Just add what the dieletric type - C0G (or NP0), X7R, X5R, Y5V etc. - is for each cap.
Why is this feature important to you?
This is important because, except for C0G/NP0, modern multilayer ceramic caps (MLCC) have a large Voltage Change with Capacitance (VCC).
For example, effect of DC bias for a general purpose 100nF 25V X7R from Murata:
http://psearch.en.murata.com/capacitor/product/GRM219R71E104KA01%23.html
#Feature Requests#Has anyone used a solder pot to solder a PCB with through-hole components? I have a 50mm square PCB but I have many of them and it's going slow with 15 components each. I have seen these solder pots online https://www.amazon.com/gp/product/B01HHKROR2/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 and I was wondering are these used to solder entire boards at once successfully? I haven't seen it done or know of any use of this method, just something I thought of. Or does anyone know of another method that is fast for soldering through-hole boards besides individually one-by-one ?
Thanks
#Skill#BUG
Concise problem statement:
There is a problem with the RAD series of electrolytic capacitor package footprints.
Their pin numbering is reversed so that the + pin on the symbol is mapped to the - pin on the footprint.
- Other RAD footprints show same fault:
https://easyeda.com/forum/topic/Electrolitic_capacitor_schematic_vs_PCB-Cc5nFlf9r
Solution:
The package pins on the RAD series of electrolytic capacitor package footprints need to be swapped.
Steps to reproduce bug:
Place electrolytic cap and a resistor from EasyEDA Libs into a schematic;
Connect resistor to cap, one wire to each end;
Apply net labels,
POSandNEGto wires to indicate cap polarityAssign a
RAD-248package to the cap symbol;
- Pass schematic into PCB;
Results:
Netlabel NEG connects to + package pin and POS connects to other package pin
Expected results:
Netlabel POS connects to + package pin and NEG connects to other package pin.
Browser:
Chrome
#Bug Reports#