How to import a new own createted 3D model (step.File)

Hi,

pre-comment:

according to the description:

Create a new 3D library

in “Top Meun - New - PCB 3D Lib”. This is not available when I open: New and follow the instruction as (link)

(https://docs.easyeda.com/en/PCBLib/PCB-3DLib-Import/index.html)

 

annyway importing .obj or WRL(VRML) files is not a the way how it should work!

When will it be possible to import .step files

.step files are the most common files used. obj or WRL file are not prctical and sofare easeda is useless!!!

 

Thanks

 

 

 

 

 

#Library#
Circuit Design
Help with setting up PCB to have a castellated part put on it

Would like to please ask for a second set of eyes to see if I've done this is a workable way ...

I just spent a bunch of time trying to define a schematic/footprint to allow me solder a castellated board onto a pcb.
Here is the castellated board that I want to solder onto my PCB:
https://www.tindie.com/products/jaspersikken/solar-harvesting-into-lithium-ion-capacitor/



In trying to get this to work, there was for me a lot of trial and error - and I'm not even sure I could recreate it now if I had to - but I think it may have ended up right.

I wasn't able to figure out how to share the part (schematic and footprint) I built, but I could create a project using it and share that project, which I have done here:
https://oshwlab.com/roblatour/weather-station-2024



I would appreciate it if someone could look at the above  project and tell me if it will work.
In short, the idea would be to solder the castellated board onto the exposed copper slots on my PCB and then have the slots connected using the Vias at the end of the slots to other components on the board.

The one thing I am most unsure of, will the via at the end of the slot be continuously connected to the slot, so that if I solder the castellated board on the slots there will be a connection all the way through to the via at the end of the slots.

#PCB#
Circuit Design
Resolving Design Rules Conflict for SMD Round Nut Placement

Hello everyone,

I am encountering an issue while attempting to position the SMD round nut from LCSC on my board (also available in the JLCPCB library):  https://www.lcsc.com/product-detail/SMD-round-nut_Sinhoo-SMTWE2015MTJ_C2928176.html The design rule check (DRC) indicates a requirement of 0.152mm, whereas the nut's polygons have a solder mask of 0.050mm.

I attempted to amend the Design Rules for the nuts to a clearance of 0.05mm, which unfortunately didn’t rectify the issue. I'm uncertain if this adjustment is correct.

I seek guidance on how to resolve this, and understanding the root cause. Could there be a mistake on my part in utilizing these nuts?

Project URL: https://oshwlab.com/logronoide/solderless-raspberry-pi-pico



Warm regards.

#PCB#
Circuit Design