I agonised as to whether I should put this issue in the 'Bug Reports' or 'LCSC' category but I felt that it is such a fundamental problem that it must be a 'bug'.
Basically, unlike every other search engine I nave ever used in my entire computing life, this one is plain useless - please watch my video: Useless EasyEDA search results
I searched for a simple component using a standard keyword and a simple phrase and the results varied from 0 (zero) to a third of a million respectively.
How can this be so?
Hiya All,
I'm trying to design a very basic single board computer, for messing around on.
I would very much appreciate if members can point out any mistakes in my design.
I've posted my question in the schematic capture forum, though I'd help with my PBC too.
I'm just learning how to use Easy EDA so I'm sure I've over looked something or other.
I tried to make my own PCB design but it was overloaded with tracks everywhere,
so then I tried the auto-router and was very surprised to see how few tracks were on it.
I haven't fully figured out how to update the 3d models, so many of the components are missing in the 3d preview.
Hopefully (if there's no errors in my settings) Below are the schemeatic and pcb links
https://easyeda.com/Jaan_Doh/p8x32a_shield_v01
Edit:
Fixed broken link
If I place a 1x16 female header (LCSC C124409) in my schematic, it displays nicely in the 3D view. Similarly, a 1x14 female header (C52711) displays properly.
But if I place a1x15 header (C124408), no 3D model shows up.
Is this a bug, or am I doing something wrong?
P.S. The male 1x15 header (LCSC C2894938) works fine.
#PCB#There seems to be something strange happening when I make a new board outline.
1. I delete the board outline then go to 'Tools/Set board outline'.
2. I select Rectangular and click 'Apply'.
3. I select the left hand edge of the outline and drag to the right.
I notice the top left hand corner shows 3 dots and a spurious line
pointing left! See Board-outline-#2
4. I then select the top edge of the board and drag upwards. The top
left hand corner now has a piece jutting out to the left! See
Board-outline-#2
5. This phenomena does not happen if I move the bottom edge or right
hand edge!
Deleting nodes in the boarder outline disconnects the board outline and
the autorouter does not like it. I can not find out how to reconnect the
board outline when it becomes disconnected so that the Autorouter will work.
Please also see my Public YT video: EasyEDA border problem This shows the problem in exquisite detail.
This video also shows that after some manipulations some of the border freezes and can not be dragged at all!








