Autorouter not functional / stuck at zero or low percent: workaround for local autorouter only.

There have been several posts about the Autorouter not completing routing and getting stuck at some low (sometimes even zero) percent completion.

Someone about 8 months ago reported something similar to this problem and suggested a workaround:

https://easyeda.com/forum/topic/Local-Autorouting-workaround-9af43ebb81b4406ea46e94abf4365a0c

but the problem still appears and since then I had forgotten all about it.

In a topic with someone else recently, I rediscovered this workaround to get the local autorouter to complete but I cannot find the topic this was in.

Anyhow here is the workaround again (edited to clarify run the autorouter rather than start the script):

  1. Run the local autorouter (Route > Autorouter) and then once that has started;
  2. run a second instance of the local autorouter, it will then route the board!

Once it completes you can close the completion message and the warnings about "cannot start another instance of the autorouter..."

Note that this trick does not work when using the cloud autorouter.

  • Please fix this problem with the local autorouter.
#Bug Reports#
Bug Reports
What is the working way to panelize your pcb for SMT?

Hi,

I just want to know the  way how to panelize my PCB for JLCPCB correctly if you are using the SMT assembly service?

At first I followed this tutorial:

https://docs.easyeda.com/en/PCB/Panelize/index.html#Panelize-by-Editor

but JLCPCB replied that my pick&place file was wrong and my order was canceled.

Do I have to follow the tutorial and choose Panel by JLCPCB at the order form at JLCPCB?

Please show me the steps to follow for PCB panelization with SMT, my PCB looks like the PCB used
in the tutorial.

image.png

#PCB#
PCB
Via or Pad

Hello all.

I am not a professional or even an electronic student. I am 50+ and work as a computer operator. Currently I do not have any job (should I say thanks to Corona Virus) and so I have spent some time doing hobby electronics I find on YouTube.

I am doing a PCB for the first time - my only experience - I tried etching one from the PCB layout I found on another site (about using ATMEGA328P as a standalone) and it was successful. That inspired me to try out different things.

Now, I cannot do those double-sided PCBs (as I am not any professional or expert). I did a schematic for the RGB Cube 4x4x4 Matrix and it was all good after I followed instructions at https://aglick.com/charliecube.html

The only problem I found that there were too many wires. So I tried doing a PCB. And this is where I am stuck. When I used EasyEda (desktop version) it generated a two layer PCB. And sadly, if I try etching it, I am certain, I will fail (not to mention that these 2-sided copper plated boards are expensive for a jobless person). So though I wanted to risk, my situation does not permit. So I am trying it out with a single layer.

Via or Pad.png

Above is a screenshot of my current PCB (though not complete). Please have a look at those red boxes. What I want to accomplish is - I would add some thin wire on those positions to complete the wiring. I also saw on a YouTube video that I can use the cut-wires from earlier use of resistors.

As of now, I have used Via for those ends. But I am not sure if they are the right tool to use. There is also something called Pads which seem to be of a larger dimension - can make it easy for my 1mm hand drill bit.

What are the differences between the two and what would be a better solution. I know (after reading) technically, neither is required, and I can just place a 1pin jumper at those ends - as I will be soldering wires.

#PCB#
Circuit Design