Hi
EasyEDA will be Down Temporary for Maintenance at 2022.04.10 9:30AM~2:00PM GMT+8:00
At that period, you can't access EasyEDA, can't save or open the online file.
If you are editing documents online, please
1, export files as EasyEDA format and save to local, when EasyEDA recover, you can import them and save, via: File - Export - EasyEDA... and File - Open - EasyEDA,
2, or you can keep the editor open, when EasyEDA recover, you can continue to save it, if you close the editor accidently, you can find out the documenr recovery at: Top menu - Advanced - Document Recovery
Any help please contact us: support@easyeda.com
Thank you
EasyEDA Team
2022.03.31
The correct way to report this error is using the Report Error tool but that is limited to only 256 characters and it is hard to report the error clearly in so few characters. Therefore I have submitted a Bug Report for this symbol (which may apply to others).
In the LCSC library there is a problem with the power pin representation of LCSC part C47994, opa2277PA
The power pins on opa2277PA.1 are OK:
opa2277PA.1 correctly includes power pins.

but there is a problem with the 'power pins' on the symbols for opa2277PA.2:
opa2277PA.2 shows two pins in the same places as the power pins on opa2277PA.1 but which have no numbers and that are not listed in the 'i' Edit Symbol tool.

opa2277PA.2 should either:
- include power pins exactly as shown on opa2277PA.1 or;
- should not show power pins at all.
As opa2277PA.2 is drawn at the moment, users connect power to the un-numbered and unlisted power pins on the symbol with then creates an 'This netlabel is not connected with any pin' warning in the schematic Design Manager for the positive and negative supply pins that is very hard for them to trace and understand as demonstrated like this:

in this topic:
https://easyeda.com/forum/topic/Netlabel-Problem-9ef1e1c4e4864132ad9ba3fbb0cd0062
#Bug Reports#Hi!
i'm trying to build a THT version of the onboard preamp Aguilar OBP-3. I'm new using Easy Eda and i cannot figure how to solve this netlabel problem for V+ and GND. I've also done a smd version and it doesn't have this issue, all i have done is replacing the parts one by one and i used pads instead of connectors (since this is quite bigger i wanted to save space). Here it is the project with the schematics: Aguilar OBP-3 THT
I used the autorouter for this project, is it reliable? for a 45x50 mm board it used 1700 mm of copper, maybe it could be a problem in term of noise? When everything will be ok, how could i obtain the frequency response of this preamp? Here it is a diagram made by Ibanez for the original one.

Thank you for any advice!






