Hello,
I'm trying to design a PCB on which I would like to have two plated through-holes, one of them being oval, sitting on the same pad (or at least connected by a trace). Is such design acceptable, following JLCPCB's capabilities?
I noticed this thread: Oval pad with two holes, which gave me some answers, and I also checked JLCPCB's capabilities, but I am still unclear whether the dimensions I am using are acceptable...
I would really appreciate getting your input on this. Here it is in "resources": OVALPAD2HOLES, and this is what it looks like:

Thanks in advance for your very precious help.
Update: I learned that I can edit a post, but I cannot edit/delete a reply. So I'll put the additional info here too:
I noticed this rule in JLCPCB's capabilities:
The minimum plated slot width is 0.65mm, which is drawn with a pad.
The slot in the screenshot above was only 0.6mm wide, so I increased it, as well as the round hole diameter, to 0.65mm.
I kept both annular rings to 0.4mm, so the two holes are still 0.8mm apart.
You can check the updated OVALPAD2HOLES resource.

Hi guys,
So this is my first PCB/Schematic in EasyEDA, I have been trying to make a PCB for a 6 key and 1 rotary encoder macropad using a pro micro that will be running QMK. I was going to use JCLPCB to make the board and solder all the SMD components on the back, I would solder on the USB_C and rotary encoder.
I have gone down a hole from soldering a pro micro on there, to actually building a pro micro into the design so I can have a centrally aligned port and change it to USB-C (Just 2.0).
Can anyone advise if my schematic looks right? And the PCB I have started I have had to take a break as it is getting way too complex and I am struggling to make everything fit/connect! I am now thinking can I just SMD a pro micro on the back in a central position that won't affect the through pins of the switches?
Feeling a little overwhelmed at the moment!
https://easyeda.com/AKiwi92/macro-pcb_copy
Cheers,
Ash





