Combine PCB and Parts Order

On https://lcsc.com/ there is an option in the checkout that says "I want to combine PCB orders to ship together." When I check the box the shipping cost goes away, but nothing else happens. How do you combine a LCSC order with an EasyEDA order?

Thanks,
jjvan

#General Discuss#
Others
4mil space and trace

The LGA-12 package pads are closer than 6 mils. I'd like to specify 4 mil spacing. This page indicates that this is an option:

https://easyeda.com/Doc/Tutorial/PCBOrderFAQ#Min-Tracing-Spacing

I see how to change the DRC, and there is a drop down box on the fab order form to change the min space. However, it doesn't give any options other than 6 mil. How do I request 4 mil fab?

#PCB#
Circuit Design
Driving high current using op amp (OPA539)

Hello everyone,

I was wondering if anyone had a suggestion for how I may drive 3 A of current through a load using the high current op amp OPA539. Link to circuit below.

https://easyeda.com/editor#id=42ccd8becba349dba7949c16eac996eb

I want my Vin (Vard) to control a current going through my load (R1 in the circuit, which is going to be 4 ohms), and the max current I want to drive through this load is 3 A (therefore in theory should only need 12 V on the op amp output).

I can manage to get a total of 1 A flowing through R1 when the load is 25 ohm, but as soon as I decrease this resistance to my target of 4 ohm the circuit breaks down and everything goes a bit wrong. Adding more voltage to the V+/V- (Vp/Vn) or Vin (Vard) seems to do nothing to help either.

I have tried many different resistor configurations around the Vout and inverting input but nothing allows me to get more than 1 A through R1. The op amp is a high current op amp which should be able to drive up to 7 A. Does anyone know if this is a limit of the simulation (definitely not a limit of the power source (have tested this)), or have any ideas of how to make this work??

Thanks in advance,

Tim

#General Discuss#
Others