Hey folks, I'm laying out a PCB using this 13.56 MHz NFC antenna footprint: https://easyeda.com/components/13-56MHz-NFC-Antenna_a91e4959524c4400bf527e26e3e5bf4b and i'm getting a weird connectivity bug in when i try to lay a trace to it's pads. With one, the trace doesn't get clipped over the pad, and with the other, the trace won't connect:

but in the part, the pads all look normal:

any ideas?
#PCB#I would appreciate any advice how to improve PCB design to achieve the highest sensitivity for the GPS signal. The design is based on S76G chip.
The tracker will be sewn or encapsulated in plastic into cat collar together with two dipole wire antennas (GPS 9.04 cm, LORA 8.20 cm, lambda/2 & lambda/4 - 5%) and fine tuned by NanoVNA.
I am not sure if I should include GND pads for both antennas to signal via shielding (GPS & LORA) and make separate grounds for digital, GPS and LORA signals, connected in one place only. The PCB is 27 x 12 mm four layers: VF signal/GND, VF GND, Power lines, Digital signals/GND. The CPWG is designed to 50 Ohms (189/90/100/4.05 w/space/er height [um]/er).
X1 is MEMS LSE 32.768kHz oscillator, X2 TCVCXO 26MHz and U2 is LDO 1.8V

Very first PCB design, see antennas:

good morning. I am designing a circuit that requires six wires to be soldered to the board and I do not know how to insert a Pad in the schematic/sheet view. I can place them in the PCB view but they do not appear in the schematic view.
the projects is not complete as I am also waiting on some part designs to be completed by LCSC and looking for options for a TI automotive load switch chip.
i think i shared the project correctly: https://easyeda.com/editor#id=0a5b71f9bedf42bba0d361121d3f5dc0
#Schematic#Tried to submit an Error Report for a broken User Contributed Footprint (from user Reflow) and got this message:

Users are warned to check all Symbols and Footprints before use especially those from the User Contributed library.
There is no way to contact user Reflow:
https://easyeda.com/reflow/components
because their page has no Message option.
If an error is found but cannot be reported, the User Contributed library will just fill up with more and more broken symbols and Footprints with no way to fix them other than to copy and correct them.
Sorry but this is not helpful.
Edit:
It appears to be possible to report the error from the Library tool.
When I submitted the report below, I did not get an error message:

I asked this question to JLCPCB and they told me to ask the EasyEDA team.
The JLCPCB design rule documents
https://jlcpcb.com/capabilities/Capabilities
label the layers as Top Layer, Layer 2, Layer 3, Bottom Layer
But EasyEDA calls them
Top Layer, Inner1, Inner2, Bottom Layer
Can somebody confirm that Inner 1 always = Layer 2 and Inner 2 always = Layer 3.
Or if not what is the sequence as I need my main ground plane to be right under the components.
Thanks








